Flowcode Support Board

Afternoon All,

Downloaded this module and started to read through the content. It talked of a CD with all the examples on it. Can this be downloaded anywhere ?

Regards

Steve

Hi

No link or attachment <s>

Regards

That's what i am asking .. Can the example files be downloaded ?
The course content describes a supplied CD

Steve

steve001 wrote: ↑

Sun Jan 16, 2022 5:04 pm

Downloaded this module and started to read through the content

Hi Steve - which module are you referring to? Do you mean the Embedded Internet course on this page?

https://www.flowcode.co.uk/education/

I have asked my colleagues if these are available and will let you know...

The Embedded Internet course files can be found here:

https://www.matrixtsl.com/eblocks/resources/

Hi Steve

Yes thats the one, thank you

Steve

Morning All,

I am Looking at using a couple of ECIO 40p's / 28p's & ENC28J60 breakout boards to experiment and do the examples with.
Am i likely to experience any issues / run into problems with these ?

https://hobbycomponents.com/wired-wirel ... ork-module

Steve

Hi Steve,
The Matrix Embedded Internet course and examples use the W5500 (WIZ Click board) so you will likely find it easier if you use the same.
The ENC28J60 is cheaper, but needs more software to drive it.
Hope that helps
Leigh

Thanks Leigh, will the ECIO's be ok also ?

Steve

Yes, should be.
The W5500 modules connect to the processor via SPI.