PIC Multiuart

For general Flowcode discussion that does not belong in the other sections.
Post Reply
DAVIDJOINER
Posts: 140
http://meble-kuchenne.info.pl
Joined: Wed Dec 02, 2020 7:35 pm
Been thanked: 18 times

PIC Multiuart

Post by DAVIDJOINER »

Hi Ben

I normally use your DSPIC 40P ECIO however in most of my projects but i notice this is now on extended delivery

However i have a couple of SPI to 4 x UART Bridge MULTIUART SPI2UART spare and also a pickit 3

Presume i can reprogram to accept new small flowcode programs

is the pin layout on the board the same as pickit 3 and any hints / advice

Or alternatively could i load a boot loader program and if so how

Best Regards

David

Post Reply