ICD Confusion

For general Flowcode discussion that does not belong in the other sections.
Post Reply
User avatar
p.erasmus
Valued Contributor
Posts: 434
http://meble-kuchenne.info.pl
Joined: Thu Dec 03, 2020 12:01 pm
Location: Russia / Россия
Has thanked: 104 times
Been thanked: 88 times

ICD Confusion

Post by p.erasmus »

Hi Team,
When I am using Scada I can display a value in a numeric display ,when I am using the ICD/Ghost running at full speed
or even single stepping the display is never updated ,I am sure this was possible in the past with sliders and other indicators
Am I missing the point here expecting something that is not possible.
P1.jpg
P1.jpg (14.01 KiB) Viewed 1674 times


P2.jpg
P2.jpg (23.63 KiB) Viewed 1674 times
Another confusion is when ICD switched ON (green bar at the bottom of sreen ON) Sometimes during compile to target the ICD code is compiled and sometimes not .
ON the PIC1938 with me it never gets compiled and not sure what the effects is but I lost many hours trying to get SPI code to work on the 1938 which is working in SCADA ,changed to a 18855 ICD code compiled and the SPI is working

Sorry if it is my understanding that is missing something

P5.jpg
P5.jpg (102.02 KiB) Viewed 1674 times

P6.jpg
P6.jpg (74.92 KiB) Viewed 1674 times
Regards Peter - QME Electronics

Post Reply