Flowcode Support Board

Welcome everyone.
I need your help.
We bought a new version license to work with STM microcontrollers because the older versions did not have STM support but we solved the problem.
When we try to make a break according to a specific pin (see the button and give the information, then go back and continue working from where the button went).
INTERRUPT works only on timers,
The Help and resources column says in the INT section, "Triggered when an external stimulus is used on an external interrupt (INT) pin (eg a Button press).
Is it really that hard to help in this situation?
No one you know on this forum?
I really need your help, please if anyone can respond to me

External interrupts certainly do work.
Please could you post your test Flowcode program?
(This gives us a lot of information about your scenario)
Thanks

Hello.
Thanks for reply.
please tell me how can I provide project file with reply.

Hi, sulkhan.
When replying, select the Attachments tab.
Select Add files then a new window will open.
Browse to the folder you have your flowchart saved in, select the file that's is then select Open.
Your flowchart should then be attached to your post.