Page 1 of 1
App Developer (SCADA Slave) API devices for ESP32
Posted: Mon Mar 28, 2022 9:52 am
by stefan.erni
Hi Ben
I guess it still needs a firmware for the ESP32 to use it as a slave.
Is this already available? Or is one already planned?
https://www.flowcode.co.uk/wiki/index.p ... ed_Devices
regards
Stefan
Re: App Developer (SCADA Slave) API devices for ESP32
Posted: Mon Mar 28, 2022 12:06 pm
by medelec35
Hi Stefan.
Have you seen
this wiki page?
Re: App Developer (SCADA Slave) API devices for ESP32
Posted: Mon Mar 28, 2022 12:07 pm
by BenR
Hi Stefan,
The firmware is available here.
https://www.flowcode.co.uk/wiki/index.p ... e_Devices)
Let us know if you have any problems.
Aha Martin beat me to it
Re: App Developer (SCADA Slave) API devices for ESP32
Posted: Mon Mar 28, 2022 3:22 pm
by stefan.erni
Hi Martin, Hi Ben
Many thanks.
I found the ZIP Folder with two program for the ESP32
ESP32_API_Comp.fcfx
ESP32_API_Firmware.fcfx
So I loaded the ESP32_API_Firmware.fcfx to my esp32 board an I can connect it to my network already.
For the App Developer I found some template .
But which of these is for the ESP32?
regards
Stefan
- api_ESP32_2022-03-28_16-12-35.jpg (35.51 KiB) Viewed 1777 times
Re: App Developer (SCADA Slave) API devices for ESP32
Posted: Tue Mar 29, 2022 7:37 am
by stefan.erni
Hi Martin, Hi Ben
I used the ATOM Matrix with a mpu6886. This mpu6886 is working with bluetooth nice on Port A25 and A21 with Flowcode.
https://www.digikey.co.uk/en/products/d ... B/12088569
I made the config for the pin in the ESP32_API_Firmware_post in the same way.
For the App I wrote a small program.
Unfortunately the init from the mpu6886 is not working.
I noticed that the wifi connection is fine, RX and TX blink when the Atom module is running and rx tx stop blinking when I turn off the Atom module
I suspect I'm doing something wrong with the I2C
regards
Stefan