Suggestions for new microcontroller support

Post here to discuss any new features, components, chips, etc, that you would like to see in Flowcode.
mehmet64
Posts: 40
http://meble-kuchenne.info.pl
Joined: Mon Apr 05, 2021 1:59 am
Has thanked: 8 times
Been thanked: 4 times

Re: Suggestions for new microcontroller support

Post by mehmet64 »

Hi Steven
how about think NUVOTON microcontrollers
Attachments
download.jpg
download.jpg (10.59 KiB) Viewed 21455 times

Oscar_T
Posts: 89
Joined: Wed Dec 02, 2020 10:06 am
Location: Italy
Has thanked: 37 times
Been thanked: 10 times

Re: Suggestions for new microcontroller support

Post by Oscar_T »

Hello

Any chance to put STM32G081KBT6 in the current flowcode version?

the current chip shortage is very critical and the stm32 products currently available are in the G or L family.

I understand the hard work behind making support for a new mcu family compatible, but it would be truly appreciated

Kind regards

SpeedPIC32
Posts: 251
Joined: Thu Dec 10, 2020 2:35 pm
Has thanked: 36 times
Been thanked: 17 times

Re: Suggestions for new microcontroller support

Post by SpeedPIC32 »

Hello all
I have discovered something interesting
Have a look here:
https://dstike.com/
many ESP8266 boards / clocks
are they supported yet?
I would be happy if these products could be programmed via FC9.
Read measurement data on your own clock,
control other devices, etc.

Greetings SpeedPic32
ESP8266.png
ESP8266.png (457.89 KiB) Viewed 21331 times

Marc-Lepage-AIF
Posts: 3
Joined: Fri Feb 12, 2021 3:29 pm
Been thanked: 1 time

Re: Suggestions for new microcontroller support

Post by Marc-Lepage-AIF »

Hi Steve,
This is the micro I would like to see in the flowcode list :
PIC18F16Q41/SO
Do you think it's possible in a short term ?
Many thanks
Marc

BenR
Matrix Staff
Posts: 1707
Joined: Mon Dec 07, 2020 10:06 am
Has thanked: 435 times
Been thanked: 598 times

Re: Suggestions for new microcontroller support

Post by BenR »

Hello,
This is the micro I would like to see in the flowcode list :
PIC18F16Q41/SO
Do you think it's possible in a short term ?
Just been looking into this one for you, it appears this device is not supported by the current PIC compiler we are using and so at the moment it's not as easy to add as it might be. You would need to use the XC8 compiler direct from Microchip to use this device.

I'll see if I can get the device added for you.
many ESP8266 boards / clocks
are they supported yet?
ESP8266 is a completely seperate toolchain and source code to the ESP32. It's something we would like but at the moment we are putting our efforts into the more capable ESP32 device. If more users would like to see the ESP8266 then please let us know.

User avatar
p.erasmus
Valued Contributor
Posts: 434
Joined: Thu Dec 03, 2020 12:01 pm
Location: Russia / Россия
Has thanked: 104 times
Been thanked: 88 times

Re: Suggestions for new microcontroller support

Post by p.erasmus »

Hi All,

You can only download the new device files from the Microchip web and install it for your compiler version so basically any version of the compiler will work with new devices that is not in the version of your compiler .
Regards Peter - QME Electronics

SpeedPIC32
Posts: 251
Joined: Thu Dec 10, 2020 2:35 pm
Has thanked: 36 times
Been thanked: 17 times

Re: Suggestions for new microcontroller support

Post by SpeedPIC32 »

hello,

I mean this clock
DSTIKE ESP32 Watch DevKit oled
i think all chips from FC are supported or?
3.png
3.png (263.25 KiB) Viewed 21230 times
2.png
2.png (318.43 KiB) Viewed 21230 times
1.png
1.png (147.05 KiB) Viewed 21230 times

This product was planned at the same time of deauther wristband. I learned a lot of experience from deauther wristband and I knew ESP32 is a better choice for a "Watch".

The breakout pads are also designed to connect different sensors.

TX/RX could be used to communicate with computer or other control board.

17/16 is IIC port could be connected with RTC module or other IIC sensors.

SVP/SVN could input ADC signals.

25/26 could output DAC signals.
What makes it special?

Small size: 3.8x4.5cm
Height:1.5cm
Double 4 layer board
600mAh battery inside
On/OFF Power Switch
OLED version:1.3OLED SH1106(SDA-17,SCL-16)

Buzzer-32
WS2812b RGB LED-33
Navigation Button(Up-19,Center-18,Down-5)
OLED version external slide button(22,23)
Highlight LED(27)
Indicate charging LED(On means Charging,OFF means Full)
Reset and Flash Button at Bottom board
Breakout GPIOs(TX,RX,17,16,SVP,SVN,25,26,GND,3V)

SD Card support

GPIO12--DAT2
GPIO13--DAT3
GPIO15--CMD
GPIO14--CLK
GPIO2--DAT0
GPIO4--DAT1
GPIO21--card

Greetings SpeedPic32

BenR
Matrix Staff
Posts: 1707
Joined: Mon Dec 07, 2020 10:06 am
Has thanked: 435 times
Been thanked: 598 times

Re: Suggestions for new microcontroller support

Post by BenR »

Hello,
I mean this clock
DSTIKE ESP32 Watch DevKit oled
i think all chips from FC are supported or?
Excellent that looks great, yes the chip will work fine with Flowcode and the display and other features should also work.

Oscar_T
Posts: 89
Joined: Wed Dec 02, 2020 10:06 am
Location: Italy
Has thanked: 37 times
Been thanked: 10 times

Re: Suggestions for new microcontroller support

Post by Oscar_T »

Hello

is it possible to add this mcu PIC32MM0128GPM036-I/MV of the mm family?

Kind Regards

stefan.erni
Valued Contributor
Posts: 738
Joined: Wed Dec 02, 2020 10:53 am
Has thanked: 149 times
Been thanked: 170 times

Re: Suggestions for new microcontroller support

Post by stefan.erni »

Hi Steve

Is it possible to support the ESP32 PICO D4?
Maybe later the ESP32 PICO V3 too?

For this ESP32 PICO D4:
There is currently no BLE profile supported in Flowcode 9,
Unfortunately, the standard configuration from Flowcode for all ESP32 Device is set to Bluetooth BLE.
The configuration must always be changed manually to Bluetooth SPP and if you are not careful it will be set back later during compilation from Bluetooth SPP back to Bluetooth BLE.
Wouldn't the standard for Bluetooth be better
BluetoothSPP (and without debugger messages)?

Could the baud rate for the ESP32 PICO D4 flashing instead of 115200 be 921600?


regards


Stefan
Pico_2021-10-20_11-30-13.png
Pico_2021-10-20_11-30-13.png (47.34 KiB) Viewed 20924 times
Pico_pin_2021-10-20_11-13-34.png
Pico_pin_2021-10-20_11-13-34.png (544.76 KiB) Viewed 20924 times

Post Reply