Module GSM M590 kit for Arduino and other chip.....

Post here to discuss any new features, components, chips, etc, that you would like to see in Flowcode.
Post Reply
solozerouno
Posts: 113
http://meble-kuchenne.info.pl
Joined: Tue Dec 08, 2020 4:36 am
Has thanked: 2 times
Been thanked: 2 times

Module GSM M590 kit for Arduino and other chip.....

Post by solozerouno »

It is possible to add a transmission module GSM based on the NEOWAY M590. I have a kit based on it and on the development board in addition to the usual vcc and 5v there are pins with the names I T V K G
If it was possible...
Thank you.
selozerouno.

BenR
Matrix Staff
Posts: 1707
Joined: Mon Dec 07, 2020 10:06 am
Has thanked: 435 times
Been thanked: 598 times

Re: Module GSM M590 kit for Arduino and other chip.....

Post by BenR »

Hello,

It looks like this module should work as is with our existing GSM component.

Though I'm not sure about the IO markings on the board you have, the chip datasheet seems to have the standard TX/RX UART interface.

Do you have a link to the board you have so we can see if there is any additional information on it?

Post Reply