Flowcode Support Board

Posted: **Wed Jul 28, 2021 3:41 pm**

It is possible to add a transmission module GSM based on the NEOWAY M590. I have a kit based on it and on the development board in addition to the usual vcc and 5v there are pins with the names I T V K G
If it was possible...
Thank you.
selozerouno.

Posted: **Thu Jul 29, 2021 9:59 am**

Hello,

It looks like this module should work as is with our existing GSM component.

Though I'm not sure about the IO markings on the board you have, the chip datasheet seems to have the standard TX/RX UART interface.

Do you have a link to the board you have so we can see if there is any additional information on it?

Flowcode Support Board

Module GSM M590 kit for Arduino and other chip.....

Module GSM M590 kit for Arduino and other chip.....

Re: Module GSM M590 kit for Arduino and other chip.....