Conseil programmation

Post here to discuss any new features, components, chips, etc, that you would like to see in Flowcode.
Post Reply
datatec73
Posts: 2
http://meble-kuchenne.info.pl
Joined: Tue Mar 09, 2021 1:11 pm

Conseil programmation

Post by datatec73 »

Bonjour a tous

Je suis actuellement sur un projet de commande de motorisation de portail linéaire.
Le projet fonctionne très bien avec le flowcode en simulation mais quand je programme le PIC (16F88) rien ne fonctionne .
Je joins la copie de mon projet
pouvez-vous m’aider ou me donner des conseils.
Merci de votre aide.

Christian
Attachments
portail bissy new 01-08-21_V6_.fcfx
(79.55 KiB) Downloaded 109 times

jgu1
Posts: 602
Joined: Thu Dec 03, 2020 8:25 pm
Location: Denmark
Has thanked: 494 times
Been thanked: 132 times

Re: Conseil programmation

Post by jgu1 »

Hello!

I cannot speak french, I used translate.

As far I see you use a 4Mhz X tal and in config you have setup to Osc: HS As far I remember you need to use Osc: XT and LOW voltage was enabled, I disable this

And is resetpin high pin 4?

I have change the config, maybe it help :D .

Br Jorgen
Attachments
portail bissy new 01-08-21_V7_.fcfx
(79.11 KiB) Downloaded 103 times

datatec73
Posts: 2
Joined: Tue Mar 09, 2021 1:11 pm

Re: Conseil programmation

Post by datatec73 »

Hello

I don't speak English and I also use the translator.
thank you for your advice and help I try to program with this option.
I will keep you informed of the result.

Christian

Post Reply