modbus slave
Posted: Tue Feb 21, 2023 12:36 am
Hello,
I am new to flowcode. I am programming an ATMEGA 2560 with flowcode V10. I am using the serial UART. I have a UART that is sending and receiving info from a weather sensor, another UART that is sending and receiving info from another sensor. These are comms on the flowcode. I want to modbus that info. Would I connect a UART to a modbus slave? I would have the computer polling the modbus slave. The examples I have seen with modbus slave use a vNet injector so I was not sure if the UART would be needed to connect to the modbus slave. I appreciate the help.
I am new to flowcode. I am programming an ATMEGA 2560 with flowcode V10. I am using the serial UART. I have a UART that is sending and receiving info from a weather sensor, another UART that is sending and receiving info from another sensor. These are comms on the flowcode. I want to modbus that info. Would I connect a UART to a modbus slave? I would have the computer polling the modbus slave. The examples I have seen with modbus slave use a vNet injector so I was not sure if the UART would be needed to connect to the modbus slave. I appreciate the help.