Problem running Component Tester free app
Posted: Sat Mar 19, 2022 4:53 pm
Hi - As a newcomer to flowcode I hope my question is not too trivial! I am unable to get the app to run on an Arduino Uno R3 SMD. In project options I have set the target to Arduino Uno R3 SMD and the compile port correctly. I can download the Arduino_Uno_App_Developer_Comp.fcfx file. If I then try to run the Open ComponentTester V1.3.bat file it fails at the first test with a message " Testing: D2,D4,R1,R3 & A1.....Fail. Click Diag Sw to return to start". However I can see no "Diag Sw". I have checked my circuitry over and again and it is correct. I have also tried Installing the other firmware file Arduino_Uno_API_Firmware.fcfx but this throws up a compilation error - "One or more pins of component Servo_Controller1 are not connected. Simulation and Compilation may not behave as expected" so I assume this is not the one to use (why are there two firmware files?).
I am really stuck so any help would be very much appreciated.
Keith
I am really stuck so any help would be very much appreciated.
Keith