Flowcode Support Board

Hello.
I have made some changes to the 2d pot slider component so the pot scale is now based on VRef instead of percentage.
If you would like to try the component before the updates are pushed.
Browse to this location using file explorer, it's hidden by default so just paste the link into your address bar. Replace the existing file with the attached file.
If Flowcode is already open, then you will need to reload your project for the new components to work
If you run any component updates, then the components you added will be overwritten

Hi

Just ran flowcode 10 update libraries and it found an updated pot slider 2d, After downloading an restarting,
the 2d pot slider reverted back to the original 0 -100%, not the updated one

That suggests the component has not yet been pushed onto the update system.

medelec35 wrote: ↑

Fri Mar 17, 2023 9:07 pm

If you run any component updates, then the components you added will be overwritten

I will let you know when the component is ready to be downloaded via updates.

Hi.
Components were pushed onto the update system today, so it should be all good to update now.