Flowcode Support Board

Hi Jorgen

Like all printers there is a steep learning curve. During mine, whilst in it's tent I printed out a small "calibration" cat. All seemed to be going well until around 70% of the way through when it broke free from the bed and failed. As it broke free when a colleague took a look, the cat is now obviously called Schrodinger

The adhesion issue is now resolved and I'm pretty much there with settings (well for that PLA).

I didn't get around to milling the PCB for the LED lights as I noticed an issue with it. I used KiCad for the first time and I'm still learning. I'm making the change to using KiCad so I'll persevere. Hopefully I'll mill the next time I'm in.

This link documents my accuracy tests with the ToF module. Not really used it since as it met my needs,

viewtopic.php?f=3&t=657

Regards

Hi Iain that sounds like there was a catastrophic failure.
I'm glad its sorted now.

Hi Jorgen
Attached is the v9 version.
The path to place the component is.

Hi

that sounds like there was a catastrophic failure.

Without paws for thought and no pussy-footing about, we grabbed the problem by the tail and swung it around as the tent provided plenty of space to purrfect the process. Feline pretty good about that.....

Regards

Thank´s Martin

Oh, what a project chipfryer

Br jorgen

Also work in FC9 Martin, but if I update after I place the new file in Component it says; "not genuine". Is it difficult to push it update?;)

I can't push the updates myself.
Therefore, any component file I update to get will show as Not genuine.