Flowcode Support Board

Thanks

Hello Martin,

Do you have any example FC10 file of using ghost with E-Block2 BL0055 Arduino ? like with BL014 combo, BL0127 Actuator or BL0162 Servo ?

Thanks again.

Hello.
I have attached a project that allows you to control a servo which must have a power supply either connected to the BL055 or BL0162.
It is using the pot of BL0114 combo board, also I'm just using a Potentiometer component for more flexibility.
Before try ICD, its best to make sure the hardware works first without using ICD.

Thanks