Flowcode Support Board

Again thank´s Ben, I will test and you hear.
Jorgen

GPIO pin mode now working too

Hi Ben!

I have made some test. The WS2812 component work perfect i real world after the 1mS delay before refresh as you said, tested on a Nano and in a ESP32 S3 too, the onboard led also work

But If I start a new project with the WS component, and I added it to 2D, the LED are squared and not work in simulation and If I use the seach and want to add on the 3D I get the message as you see on the picture.

Br Jorgen

Hello,

It looks like dragging the component onto the panel works correctly for 2d and 3d panels, but right clicking the component has the problem. I'll chat with Steve about it.