Flowcode Support Board

Hello,

I have seen some posts that indicate that the staff would be willing to convert an old .fcf file to the current .fcfx format so I can open it in the newest version of Flowcode. I have attached the file to convert and would much appreciate it if someone could do that for me.

Please note that I have renamed the file as an .fcfx file because the forum would not allow me to post it otherwise.

Hope that makes sense.

Thanks so much!

Hello.
I have converted the file for you.

Hi Martin!

How did you convert this file, do you start from scratch, step by step and make a new program or is there a way to do it from Fc9?
Please

Br jorgen

Thanks so much!


Greatly appreciated!

Best,

Dan

Hi jorgen.
I used Flowcode v7 to convert the file. Hi Dan.
You're welcome.
Hopefully, it works as intended.

Ok Martin, thank´s

Jorgen