Page 1 of 1
PIC24FJ128GB204 IOC simulation and pin config
Posted: Sun Nov 06, 2022 12:40 pm
by keithh534
With interrupts enabled and breakpoints inserted, Flowcode closes after a few seconds at a breakpoint. The pin configurator for the processor only allows "Trigger on both edges".
Re: PIC24FJ128GB204 IOC simulation and pin config
Posted: Mon Nov 07, 2022 2:42 pm
by BenR
Hello,
Please can you post the project that shows this behaviour so we can investigate. There is a known bug in the application regarding simulated interrupt pins which is due to be fixed shortly, likely this week.
Re: PIC24FJ128GB204 IOC simulation and pin config
Posted: Fri Dec 30, 2022 11:43 pm
by keithh534
It is now 30 December 2022 and the bug is still not fixed. When will it be addressed?
Re: PIC24FJ128GB204 IOC simulation and pin config
Posted: Sat Dec 31, 2022 11:45 am
by Steve-Matrix
The bug Ben was referring to was fixed at the beginning of November. Please see
this post for the details.
I am not sure if this relates to your problem. As Ben said, please post an example project showing this behaviour and we'll be happy to look into it.