Page 1 of 1
help termistor setting 104GT-2
Posted: Thu Dec 22, 2022 3:10 pm
by d820513
thermistor semitec 104GT-2
0 - 300с
how is the correct flowcode setting for this thermistor
an example if possible, thanks
Re: help termistor setting 104GT-2
Posted: Thu Dec 22, 2022 7:27 pm
by medelec35
hello.
You will need to add the Thermistor component.
Look at the thermistor datasheet then enter the values within the thermistor component properties.
Re: help termistor setting 104GT-2
Posted: Fri Dec 23, 2022 3:06 pm
by d820513
where to get this value ?
Re: help termistor setting 104GT-2
Posted: Fri Dec 23, 2022 3:09 pm
by d820513
i can't figure it out
Re: help termistor setting 104GT-2
Posted: Fri Dec 23, 2022 10:18 pm
by chipfryer27
Hi
There doesn't seem to be a lot of results if you search for the 104GT2 resistance table, but as many 3D printers use this component you may get better help from one of their sites.
This link documents a table, but you might want to search further.
https://e3d-online.zendesk.com/hc/en-us ... stor-Table
Hope it helps.
Regards
Re: help termistor setting 104GT-2
Posted: Sat Dec 24, 2022 11:25 am
by medelec35
Hello.
What I just did is enter the standard formula in excel for deriving the resistance for a given temperature.
These are the results:
- R vs Temp 100k.png (9.57 KiB) Viewed 1788 times
You can either enter those values within the component properties or use one of the many
online calculators, since the beta value is shown on the datasheet.
Another option is to use a formula to display the temperature.
I posted a project doing that,
here.