Flowcode Support Board

Hello,
I am new here. I have Flowcode V10, professional license, with AVR chip pack. I was trying the 'compile to target' from Flowcode on a ATTINY85 with ATMEL ICE programmer. I get the following error "avrdude.exe: Error: Could not find USBtiny device (0x1781/0xc9f)." I was wondering if anyone else has had this issue and what you did to remedy this? I tried searching the wiki but could'nt find anything that I could use to help.

Note: I did compile the .hex file. I went to Mirochip studio and programmed the .hex code to the ATTINY85. I had no issues.

As well as searching the wiki, it's also useful to search this forum and the old Flowcode forum.

For example, I found the following post on this forum which seems to shown a solution to the same issue you are having:
viewtopic.php?p=2822#p2822