Flowcode Support Board

Hi everyone

I still have problems compiling code with WiFi and NTP time on esp WiFi kit 32. I can control outputs and write to display ok. All libraries and software upto date.

Thanks
Wayne M

Hi

I'm guessing this is a follow on to previous posts?

As a few others can compile OK (at least to Hex) it would appear that perhaps the issue is local to your installation. Can you try and narrow it down a bit?

Could you create a simple chart that does compile then add in each component in turn? That may help point to the issue.

Regards

I have done this. I can control outputs and write to LCD this is ok.
I have added WiFi Comms as read said and it fails also added NTP time with WiFi and fails to compile.

Wayne m