Flowcode Support Board

Hi!

Stupid

I have today reinstalled PLC programmenr on my laptop CX programmer. After that My FC10 doesnt work. I have uninstall CX programmer FC 10 stil not work. It would not copile or anything. Then I try to run the ESP toolchain again. Now it will compile the program ,but not to the target I get this message:
C:\Program Files (x86)\Flowcode v10\tools\DoNothing\DoNothing.exe
ERROR: Can not launch process: Adgang n�gtet.

Look like it´s something to the programmer, what am I missing, please help, I prefer FC10 rather than CX programmer

Br jorgen

Hi Jorgen,

It's all compiled ok so that's a good start the ESP toolchain is still working, however it's struggling to find the path to the dummy exe as there is no linker for ESP.

Can you check the file path is ok.

C:\Program Files (x86)\Flowcode v10\tools\DoNothing\DoNothing.exe

Hi Ben!

Thank you again for fast reply.

Your advice helped.

Something was wrong in the lib Program files(86) and FC9 was not possible to start too. I uninstall and reinstall FC9 and FC10 run the core and update, after that I am back in the "fold again". Both working.

Now I know, this labtop is ONLY for FC and not for PLC´
Thank´s
Br Jorgen.