Flowcode Support Board

No pwm output on any channel, I have tried both 8 and 12 bit set duty cycle on all 3 channels but to no avail, Am running at 16MHz clock with a 16KHz PWM frequency. Have tried all combinations of OSCCON system select bits. Analog inputs work OK. Did have a problem with having OSCCON as the first statement in flowcode , the chip would only run at default frequency (500KHz) but putting an output statement at the beginning solved that.

Hello,

Please can you post your Flowcode project file and we will investigate for you.

Hi Ben, forgot to mention that all is OK in simulation but will not work when programmed in to a chip, have tried 3 chips all with the same problem. sorry for the delay in replying but been away.
Barry