Flowcode Support Board

Hello good Day. I am using FC v10.
I am working on the GSM COMMUNICATION Project (CP2832-01). I am not using the GLCD.
I am using the LCD screen on my E-Blocks System. I am having a problem with the Screen. Where the information is not printed properly on the LCD screen. As I am following the Manual.

Both the FC v10 software and the E-Blocks (Modular) having the same issue.
I attached the LCD image along with my program.
Any help would be appreciated. please

Hi

If you search the WiKi and forums you will find plenty of examples on using ESP32 / HX711. I'm not so sure about the fingerprint reader though.

Regards