Flowcode Support Board

Hi,
The APA102 demo project (and others I have saved from it) do not save the port pins. I set the clock pin to G2 and MOSI to G25 and all works fine. When I re open the project they have reverted back to G10 & G11.

Bob

Hi Bob.
Hopefully, this will sort your issue out.
Browse to this location using file explorer , it's hidden by default so just paste the link into your address bar. Place the attached component.
If Flowcode is already open, then you will need to reload your project for the new component to work
If you run any component updates, then the component you added will be overwritten, so it will stop working again.