Flowcode Support Board

Hi,

I'm running the latest version of FC10 Pro.

If I add the servo control component to an ESP project (ES32 S2 VROOM currently) it will fail to compile. I have configured the component in multiple ways, but without joy. The component seems to compile and run on other targets without issue.

Thanks,

MB

The problem also persists with the PWM component, displaying that: "#error MCPWM is not supported in this chip target"

Hello.
Can you post your .fcfx, .c and msg.txt files and I will see if I can sport the cause.
If you want to keep your project private, then you can pm the files to me.