Flowcode Support Board

Hello,

After some hiatus back on a PIC 8 bit project with FC9. New PC and need to re-install the 8-bit toolchain.
The toolchain download page which is geared to FC10 says that the PIC8 toolchain for other than FC10 needs to be downloaded 'from the appropriate section on your account page' (link).
However, there it gives the same message - you need to download from the appropriate page bla bla.
I get dizzy from going around that loop ...
Where do I find the toolchains for FC9 including PIC 8 bit?

Jan

When you visit your account page you should be able to download the installer from the "download" dropdown in the "Flowcode 9" section.

Maybe I am stupid, but whatever I try, I end up here.
No FC 9 account page in sight, in none of the tabs.

Jan

Hi Jan.
Instead of Buy Flowcode top link, you should select Download top link.
If you are not logged in, you will be prompted to log in first.

I was stupid. Just found it, it's under downloads on the FC10 page....
As Martin said above.

Jan

For future reference, all toolchain downloads are also under the relevant Flowcode version on your account page as per this image.