Flowcode Support Board

Hi,
I would like the integration in FC9
The part is quick and cheap

The MPLAB® Snap In-Circuit Debugger/Programmer allows affordable, fast and easy debugging and programming of PIC®, dsPIC®, AVR and SAM flash MCUs and MPUs, using the powerful graphical user interface of MPLAB X Integrated Development Environment (IDE) version 5.05 or later. The MPLAB Snap can be connected to a computer using a High-Speed USB 2.0 interface and can be connected to the target via an 8-pin Single In-Line (SIL) connector. The connector uses two device I/O pins and the reset line to implement in-circuit debugging and In-Circuit Serial Programming™ (ICSP™). It has all the speed and features entry-level users need to quickly debug their prototype.

The MPLAB Snap programs fast, with a powerful 32-bit 300MHz SAME70 MCU for quicker debug iterations. Along with a wide target voltage, the MPLAB Snap supports advanced interfaces such as 4-wire JTAG and Serial Wire Debug with streaming data gateway, while being backward compatible for demo boards, headers and target systems using 2-wire JTAG and ICSP.

Note: The Snap is compatible with MPLAB X IDE version 5.05 and later.


Sincerely
SpeedPic32

Hello,

Many thanks for the suggestion. I've added details on how to use the Snap programmer to this page on our wiki.

https://www.flowcode.co.uk/wiki/index.p ... ming_Tools

Hi Ben,
i wish for the debuger function in FC9.

thanks Ben

HI

If you follow the instruction in V9 it will work in V9
this settings is not relevant to what version the example shows ,
just follow the instruction in V9

Ha OK I missed the debugger part sorry for my comment !!

Hello,

The debugging functionality may only be available inside MPLABX.

You can take the C code generated by Flowcode and load it into MPLABX if you want to use the debugging.

Inside Flowcode we currently only support Ghost based debuging as seen on E-blocks and Flowkit hardware.

Hello Ben,
is there an example or a tutorial video