Flowcode Support Board

Hello, this error occurred after upgrading. What should I do，
In the first few days, after reporting to WS8211, I sent the file you posted on the forum（ https://www.flowcode.co.uk/forums/downl ... p?id=10494 ）I copied and pasted it into% ProgramData% \ MatrixTSL \ FlowcodeV10 \ Components, and encountered the error after upgrading today. What should I do? Acknowledgments

The upgrade is proceeding normally, but when adding the ws8211 component after the upgrade, the above error message appears

After deleting LEDw_S2811.fcpx and upgrading it again, the error shown in the above diagram still occurs。

Hi niedian
Many thanks for the spot.
I can replicate the issue, so I have attached an updated version for you to try.

Browse to this location using file explorer , it's hidden by default so just paste the link into your address bar. Place the attached component.

If Flowcode is already open, then you will need to reload your project for the new component to work
If you run any component updates, then the component you added will be overwritten, so it will stop working again (unless the component update has been pushed).

I did it your way and it's back to normal. You're amazing, thank you very much.

That's great, your welcome
Thanks for letting me know.
I will make sure the updated version goes to the component database.