Flowcode Support Board

Hi Matrix Team,

I have had many problems today. With the following single step into works sometimes for many steps then just runs the code. Code not stopping on breakpoints. I thought this maybe down to the speed in which the simulation was running at so tried to run at lower simulation speed but it was unusable. Had problems using S to stop the code running sometimes will crash.
Cant wait to see were app builder is going.


Thanks,
Wayne M

Thanks, Wayne.

There is an update of Flowcode coming soon. It does have a fix for a similar issue, so I hope that will solve it.

But if not, then please send me a simple example that replicates the problem and I will be able to investigate more easily.