Flowcode Support Board

Hello,

i downloaded the toolchain for ESP32. However, if i try to install it i get an error message:

This program can only be installed on versions of Windows designed for the following processor architectures:

x64

I run Flowcode V9 on a Macbook under Parallels. Windows 10 in 32bit version without problems. I checked the Windows architecture i have and it says: x64, so i don`t understand why its not installing...?

Any help is appreciated!

Thanks a lot

maridd

Unfortunately the ESP toolchain is not our product and is beyond our control to fix. Espressif's site says the following:

Currently only 64-bit versions of Windows are supported. 32-bit Windows can use the Legacy GNU Make Build System.

This might provide you with a solution, but we're limited in how we can help you with this.

Hi,

okay, i will check that out. Thanks a lot...!

maridd