Flowcode Support Board

hello steven trying to down load to a chip pic 16f88 .programe compiles wont load it responds with not for commercial use top of
page
it reads .you do not have a valid licence to perform this action. can you please advice as to what licence would be used for this i have the v10 hobby version

help pointing me in the right direction would be much appreciated thanks kev

Hello.
So long as you are only using Flowcode for your hobby then ' Not for commercial use' can be ignored.
With regards to 'You do not have a valid licence to perform this action', you have left some important information out.
What version of Flowcode are you using & can you attach your project .msg.txt and .fcfx files.

Edit.
I have just looked at some of your other posts and the answer for 'You do not have a valid licence to perform this action' has been answered here.
The reason 16F18877 works without the PIC8 bit licence is because the 16F18877 is a free target device.
See here and select Microchip under Free for makers.

The issue could be you have not purchased or activated PIC8 Bit chip pack.