Flowcode Support Board

Hi.
Looking for advice on getting this flowcode v9 Scada file working, using an Arduino uno.
The uno is working when I load a flowcode v9 leds file.
But the Scada file does nothing, do I need to install a file for the Uno, before running flowcode v9.1?
Or am a missing some thing in my Scada file.?
System layout
Win10 pro, all updates
Flowcode V9.1 all updates.
Regards Roy

Also tried flowcode v8, no luck yet, all updates installed

Hi

You need to flash the UNO with the SCADA hex file(which is down loadable from the UNO scada wiki page) before you can run scada from Flowcode is my understanding of SCADA
then you need to place a UNO Scada component on your panel if you make a new FC chart and want to use SCADA

p.erasmus wrote: ↑

Sat May 08, 2021 3:55 pm

Hi

You need to flash the UNO with the SCADA hex file(which is down loadable from the UNO scada wiki page) before you can run scada from Flowcode is my understanding of SCADA
then you need to place a UNO Scada component on your panel if you make a new FC chart and want to use SCADA

Thank for the info, was using the wrong hex,found the right one on wiki
now all is working
Regards Roy.

Hi, Roy.
For details on how to set up the App to store properties and data + graph etc. I would suggest looking at the code for Three channel temperature logger - Arduino, USB available from here
For future reference, the instructions within Documentation link, gives you a step by step guide on how to get the App Developer set up and running.