Matrix user forums

Dear Steve,

Thanks a lot for your answer and I read your linked posts.
As mentioned, I did solute this problem by removing FC4 and re-installing.
(Before, I tried the option "Repair" of the installation, but that does not had effects)

Thanks

Dear mr, mrs ,

Please help, I use Windows 10 x 64 using Flowcode 4 and Flowcode 6 both.
Until a few days ago, I had no any trouble whatsoever compiling a flowchart in FlowCode 4 into a hex file and writing it to a PIC via the EB-006-00-7 board. However, I’m now suddenly getting the persistent ...

Dear Steve,

Thanks a lot, (also for your quick response)
THIS WORKS, GREAT!

With kind regards,

Reinier

I have also a connection problem with EB 006-00-7 using FC4 with also PPP v3.9. This problem reased when I renewed my PC with Windows 10x64.
Compiling to a PIC under my old Windows 7 x64 was never a problem. But installing the PPP driver "DPInstAmd64.exe" it failed under Windows 10.
Recently, I ...

Dear Benj,

Unfortunately, I have the same behavior with the try version of flowcode 8.
Only the 4 UID bytes will be given properly, but other data is not clear for me. I Did not understand.

I Tried with several Mifare 1k card and a tag.

Especially the BCC check of byte 5 is good to show the ...

Dear Benj,

There are no any problems with the hardware connection. I use a PIC 16f1937 and a 3,3volt level separator of the MFRC522 board.

I tried your new routine and see that I can display the 4 bytes [0 to 3] of the UID of a 1k Mifare card as well. (compare it with my eb052) . This sounds good ...

Hi Benj,

Is there any solution to use the new RFID_MFRC522.fcpx component for Flowcode v6 ?

In August of 2016 I find also bad data with the component RFID_MFRC522.fcpx component using the Arduno board.
(I will use to program a PIC 16f1937 with a multi programmer eb006)
I'm happy that there is a ...

Hi Enamul,

Thanks for your quick reply. I'm interesting into your experiences

Thanks,

Reinier

Dear Enamul, David ...

Perhaps this topic is not specific the 18f4680 but I tried again to program a 16F chip to use ICD . I study again the connection and checked all by DMM : all looks fine. The custom board with the PICmicro is very simple (Res of 10k MCLR to VDD : acc. spec , VDD is comming ...

Dear David,

I had a comparable problem with ICD and my EB006-00-7. I tried to flash a (simple) 16F88 directly with the 16F88 socket on the board. (Of course , I wired MCLR , PGD, PGC , + 5V and GND correctly to my custom PCB with a self made cable) To avoid conflcts, I was very careful with circuit ...