Matrix user forums

Well Steve ... that would be icing on the cake!

Thank you again. and all the best ... Tom.

Another short update Steve ... It's working again!... this time I hope for good :D What I did was ... I changed the clock speed back from 4000000 to 19660800 and I got the two lines back that I said were missing in the HEX files I had been producing (that still puzzles me a bit but maybe you'll unde...

Hi Steve ... Now things are getting a bit wierd! The good news is that I got it all working .... ! The bad news is that it happened only once, with one particular set-up in Flowcode and I can't seem to repeat my success, even by trying the same process I used to get it going ... here's what I did. F...

Hi Steve ... I'm not really any further forward but here's the story to date ... I created a small test program with Flowcode3 for a 16F84A and inspected the hex to see if I could identify any config info. I couldn't, so I copied the hex text file to the programming system, loaded it and tried, as t...

Steve .... I dug out my old experimental files and converted one, so here you go ... :020000003128A5 :100008008828820732342C34083406340C340134FE :10001800023400348207203445347834703465342F :10002800723469346D3465346E34743469346E34C2 ........... :100108008128900B7F2808008D00030883128C003B :1001180003...

Hi Steve ...

Thanks for the additional detail, it will prove useful. The only thing I have to go on from the Brunning website is mentioned in the last entry on this page: http://brunningsoftware.co.uk/problems.htm Fingers crossed that it's just me and not some incompatibility!

Regards ... Tom.

Hi Ben .. thanks for your reply.

This confirmation is all I need for now, so I'll wait to hear back from Brunning Software about the issue.

Regards .. Tom.

Hello All ... First post in this group ... please treat me as not being too experienced! A while back (years ago) I purchased a PIC training system from Brunning Software. For unavoidable reasons I didn't get down to using it much but have recently pulled it back into service because I've got more t...