Matrix user forums

Hello,
I also tried to test using the Safe Mode and removing mLoader from Flowcode 7 but gave me the same problem. Any assistance you could extend me is greatly appreciated. Thank you for your time.
Carlos

Hello, You are absolutely correct about my previous inquiries about this problem. I decided to temporarily stop the inquiry because of frustration maybe. But I would like to give it another try. And I apologize for my actions. Anyway, I did almost all the suggestions except the procedure which is ab...

Hello, Thanks for your response. Regarding your questions: yes, I did install the driver for BL0080 microcontroller board and my Dell laptop's device manager recorgnizes it accordingly. However, when I upload the code, mLoader immediately shows " no device detected." Please see attachments...

Hello, I have a problem uploading codes from FLOWCODE8 (ver. 8.0.0.6) to my BL0080 microcontroller board. I am not really sure if it is going to solve my problem but below please find the procedure about communicating with a device using USB. Any help regarding my problem is greatly appreciated. Tha...

Hello Benj,
I just would like to inform you that I sent a message regarding my problem with attachments. Hope you received it. Thanks.

Carlos

Hello Benj, I decided to buy the DriverEasy in order to solve my problem. Unfortunately it did not fix the problem. Based from a computer repair personnel I inquired from it might have been the device firmware that is causing the problem. I have a Dell Laptop Inspiron 15 7000 Series and I believe it...

Hello Benj,
Up to this time I am unable to make my BL0080 Multiprogrammer communicate with Flowcode8 . Every time I try to compile the code to the programmer it keeps saying "Device not detected". Any suggestion about this problem is greatly appeciated. Thanks.

Carlos

Hello Benj, Thanks for your quick response. I downloaded the driver that you suggested and unluckily it is doing the same thing. When I connect the BL0080 dev. board it shows connected based from the device manager but under Custom USB device. Also, when I check the events portion of my device under...

Hello, I just acquired a BL0080 Multiprogrammer and also Flowcode V8. My problem is I could not load the finished program into the Multiprogrammer. mLoader keeps showing that my device is not detected....I have downloaded the necessary drivers for the device. I am using a Windows 10 operating system...