WIZ810 closing socket 0

[leoo]

Good day,
I am experiencing a problem when using the WIZ810Mj component, as follows:
After passing data on two open sockets, e.g., socket 0 and socket 1, when closing the non-zero socket (i.e. socket 1, 2, or 3) , socket 0 always closes, too, without being told to close. This is experienced in FC7, FC8, and FC10.

It would be appreciated if someone could please comment as to whether this is an issue within the component itself, or whether the problem lies elsewhere.

Kind regards.
Leo

[viktor_au]

Hi Leo
This forrum is basically closed.
If you lucky, somebody from flowcode team will see your message.
If you use FC10, go to a new forum.

[Steve]

As Viktor says, this forum is rarely used for new posts, but is retained so users can refer to previous topics.

As this is a V10 issue, please post with details onto the Flowcode forum.