Matrix user forums

Hi kersing
Rigtigt mange tak.
Never used these terminals before. But is now connected as you refer to;-)
""

Here' I do not really know what you mean here!
"And of course set the component to use that serial port"
Is it RX Remap Pin Port E.1. Or what do you mean? Should "Port E.1" be connected to a serial port. Where is this "serial port"?

The serial port settings you show are correct IF the jumper settings in the Miac are correct. Check the data sheet to see the jumper settings (page 11, one of the first three diagrams is OK)

Check the documentation of your GPS module to see if it uses 9600 bps or 38400 bps for the communication speed.

Hi kersing
Thank you very much.
Looking at it tomorrow. OK

Hi kersing
Would like to be careful here not to pills too much in dsPIC Miac!
Can you see which jumper to move And to which??

Please check the documentation. I mentioned the page and settings in my previous message.

Hi kersing
Which jumper settings in the Miac are correct????
Is this this jump settinge to be used below?

one of the first three diagrams is OK

So that one is correct, but the settings in your picture are correct as well.

Hi kersing
So burned off GPS

Have you checked the gps documentation for the default communication settings?

If you happen to have a serial to usb converter you can connect the gps to it to check it is working as expected.

Hi kersing

Have both before and now where GPS does not work anymore.
And test the GPS device on ardunie uno.
So GPS is OFF