Matrix user forums

Good day Forum.

I'm trying out the new flowcode with my Pickit 3, but when i run the script I get the following error.

Launching the linker/assembler...
C:\Program Files\Flowcode\v5\Tools\PICkit3\PK3CMD.exe -P18F2550 -FPickit Test.hex -E -M -Y -V5
Return code = -1073741515
Flowcode was unable to transfer the flowchart to the microcontroller. Check the programmer options and physical connections.

The pickit works fine in mplabx.
And i did set the parameters to according to http://www.matrixmultimedia.com/support ... w=previous

Thank you

Hi Koos,

I will have to check this on tuesday when i get back into the office, i wrote that FAQ quickly and forgot to check it was correct, shush dont tell my boss tho

Thanks David. I will send a letter of complaint to you boss.
No just kidding.