Matrix user forums

Flowcode V5.2
Use CAN macro, sending, receiving communication, in FlowServer cannot simulation.
The following example, please help me!

Hi
I had the same problem yesterday. Vnet would set everything up ok, but when I ran the simulation it didnt work.
i.e i could operate the tx sim but the rx did nt respond.

Just tried a simlation using RS232 and that does give a response over the VNET server
CAN works in FC4 using some of the Matrix sample files.

Hello,

There does seem to be an error in the CAN over v-net, we will look into this. Thanks for the heads up.

Additionally I will move this to the appropriate V5 forum.

Hello,

This has now been fixed, please see the Minor v5.2 fixes thread here: http://www.matrixmultimedia.com/mmforum ... 46&t=10669

Additionally, your programs were a little inefficient and with Flowcode v5's improved simulation speed caused minor hiccups in the simulation, these have been improved and attached.