Page 1 of 1
Dev Board V3 Drivers?
Posted: Thu Jul 12, 2012 2:57 pm
by Cruster
Hi,
Two questions:
I have a devlopment board Mk3 (HP-488-00-3) purchased long ago from yourselves with, I think C and Assembler at the same time. Both long lost after several house moves.
1) From where can I download the USB drivers for the board? The onboard chip has a label stating PPP firmware but no version number
-and-
2) Is it possible to obtain the assembler compiler from yourselves?
Kind regards,
Chris
Re: Dev Board V3 Drivers?
Posted: Thu Jul 12, 2012 3:06 pm
by JohnCrow
Hi Chris
You can download the driver for the dev board from here
http://www.matrixmultimedia.com/product ... PHPSESSID=
Re: Dev Board V3 Drivers?
Posted: Thu Jul 12, 2012 3:29 pm
by Cruster
Hi John,
Thank you for that. Downloaded USB driver and installed.
I'm guessing I need "ppp" as well? Is that a download (assuming I can not locate my original disk which came with the board) or is that available as a separate purchase from yourselves? If so, where?
Do you still sell the assembler you once did or is that now obsolete?
Kind regards,
Chris
Re: Dev Board V3 Drivers?
Posted: Thu Jul 12, 2012 3:50 pm
by JohnCrow
Hi Chris
I dont work for Matrix
Just a very satisfied customer.
You can download PPP here
http://www.matrixmultimedia.com/lc_index.php
Assembler package is not a download, the link to the page is here
Think that is what you mean.
http://www.matrixmultimedia.com/eblockscourseware.php
Re: Dev Board V3 Drivers?
Posted: Thu Jul 12, 2012 3:52 pm
by Cruster
Oops - sorry John!
For some reason I'd assumed you did work for Matrix. My apologies and thank you very much for the links. All I can seem to find is flow code everywhere!
All the best,
Chris
Re: Dev Board V3 Drivers?
Posted: Thu Jul 12, 2012 9:58 pm
by DavidA
Hi!
I do work for Matrix
We do still sell the Assembly course, but if you have a 64bit computer there may be a few fixes you need to do before using it, these are available from our FAQ site.
Re: Dev Board V3 Drivers?
Posted: Fri Jul 13, 2012 4:01 pm
by Cruster
Hi David,
Thanks, this is puzzling as I'm pretty certain that wasn't the original assembly course I ordered... I'm now wondering whether it may have been someone elses. As the whole package came together with the MK3 dev board (and I think a C primer as well)
Did the late John Becker work for Matrix? I have feeling it may have been his assembler but I'm not entirely sure... wish I could lay my hands on my original disks! Ho hum. I may stick with Mplab and PPP for the time being!
Best wishes,
Chris