Page 1 of 1
Wireless Network
Posted: Thu Oct 17, 2013 3:22 am
by gumilard
Hi,
guys, I want to build a wireless network for a building at least 250m range.
here is my goal... I want to build one master with multiple slave..
Master will transfer all the information to whole of slave while slave is only "listening".
the problem is I don't know how I must start..
what e-block should I used? will the EB RF 433 suitable for my application?
I want to build them with pic micro. any other idea is welcome
appreciate for the answer
thanks,
Re: Wireless Network
Posted: Thu Oct 17, 2013 9:32 am
by Benj
Hello,
Zigbee might be a good solution for you as it is a mesh based network i.e. each node can act as a re-transmitter to extend the range of the network. ZIgbee however is designed for low data throughput, what kind of data bandwidth are you after?
Re: Wireless Network
Posted: Thu Oct 17, 2013 10:21 am
by gumilard
Not sure for this, but I hope I can send at least a switch on/off command and some additional time code like hh:mm:ss through to all slaves

Re: Wireless Network
Posted: Thu Oct 17, 2013 12:23 pm
by Benj
Hello,
Zigbee was basically designed for switching things on and off and works in a way that a message is bounced around until all nodes have received it. Sounds like it might be ideal for what you want.
Re: Wireless Network
Posted: Fri Oct 18, 2013 2:23 am
by gumilard
hi,
thanks ben, I will try to evaluate it..
but basically I want to build that wireless communication for replace the old one using RS485 com so no more cable to use. Could that zigbee suitable for this?
Re: Wireless Network
Posted: Sat Oct 19, 2013 8:47 am
by Steve001
Morning,
You could have a look at xbee stuff there are quite a lot of breakout boards about
Data sheet is here couldn't upload as too large
http://ftp1.digi.com/support/documentat ... 0976_G.pdf
http://www.digi.com/support/productdetail?pid=4549
Features of XBee Pro 63mW Wire Antenna - Series 2B (ZigBee Mesh)
https://www.sparkfun.com/products/10421
3.3V @ 295mA
250kbps Max data rate
63mW output (+17dBm)
1 mile (1600m) range
Wire Antenna
Fully FCC certified
6 10-bit ADC input pins
8 digital IO pins
128-bit encryption
Local or over-air configuration
AT or API command set
Just be aware there is compatibility issues between the series ie series 1 will not talk to a series 2 or 2b and visa vera
this book : - Building Wireless Sensor Networks is quite good
http://www.amazon.co.uk/Building-Wirele ... 0596807732
Regards
Steve
Re: Wireless Network
Posted: Mon Oct 21, 2013 3:14 am
by gumilard
hello steve
thank for your concern.
these link is about enough to me to getting start..
thank you
