Matrix user forums

Hello flowcode community,

i've a question regarding the EB011 Power Board.
The datasheet says that every channel produces 600mA if needed (ignoring the fuses which are on 500mA). But they also say "Up to 4 full H-Bridge configuration outputs enabling up to 1200mA", but how do i need to connect my circuit (laser driver) to the board to get the full 1200mA (ignoring the fuses again)?

This is a drawing of how i think it needs to be connected, but i'm not sure though.

Does anyone know if I can get the full 1 Amp with this circuit?
I would put on the the forth and the fifth port on on high (1) and the sixth and the seventh on low (0).
I hope that I don't fry the circuit when i connect the cables like drawn on the "schematic"