Matrix user forums

Hello

I am looking to use a 12 bit ADC input to vary a frequency of an output between 0 and around 45Khz.

I have chosen to use the PIC18f4423 and I thought that the PWM component may be able to do this. I was hoping not to go down the bit banging route.

The issue I am having is that T=1/f, so trying to get a linear frequency output is difficult.

Any help on this would be appreciated - example V5 codes would be useful too,

thanks

Doing 45000 / 4096 gives you 11Hz (approx).
Calculate the frequency set by the ADC by doing ADC_val * 45000 / 4096.

The next thing to do is set the PWM so that the frequency output is the same as the one calculated, but I'm not sure the PWM can output all frequencies, especially the lower ones.

There are a lot of website that will calculate the different values to set the PWM register. Search how they calculate the values for the registers and implement it to your code. Your pretty much done if you do this.

PS : If you have Flowcode v5, then I suggest you go to the v5 section of the forum.