Matrix user forums

I am having problems with simulating the arduino mega 2560 analog channels..
I set it up with the regular potentiometer set to channel 0
Then i make a int called Pot1
I use the Getint macro
The simulation debugger will only return 0 at any setting of the simulated pot
I open op the Analog input window and it will return byte, percent and Uint values but will not return a Raw
I change my target chip to arduino uno pdip and all works well.

I have not seen how it reacts on the real micro put i would assume if the simulation has a problem most likely the real chip will to.. plus its not very helpful with testing and debugging when its not working in sim.

Br,
Slade

This is a software bug and not a bug in my flowchart

This problem occurs with the arduino1280 , arduino mega 2560 adk, and arduino mega 2560 from the ones i have checked... A simple way to work around this for now is to select the chips from the AVR atmega list and not the arduino list.

Thanks. I've logged the bug for fixing asap.
Leigh