Page 1 of 1
EB 006 Version 9
Posted: Wed Apr 29, 2015 4:57 pm
by Beertree
Hi at all, I just started with Flowcode 6 and the Multiprogrammer EB-006-00-9, supplied by usb. Power LED is on. when I try to Programm the device, i get the following Error.
What is wrong? Using the external supply makes no difference.
Re: EB 006 Version 9
Posted: Wed Apr 29, 2015 5:15 pm
by Benj
Hello,
Please can you confirm that all the following jumpers are connected horizontally and also let us know what positions they are in?
J15 Target Voltage
J11 Voltage Source
J12-J14 Prog Source
I would recommend these settings for USB based power.
J15 - 5V
J11 - USB
J12-J14 - USB
Re: EB 006 Version 9
Posted: Thu Apr 30, 2015 8:13 am
by Beertree
Hi,
Thank you for the fast response. Using USB-Power does not work either. I now solved the problem myself. When I feed in 5V directly (after the regulator) everything works fine. The board is simply not ok.
Re: EB 006 Version 9
Posted: Fri Jul 03, 2015 11:53 pm
by john_m0ers
Hi,
out of curiosity, what voltage were you using to start with?
thanks
john
Re: EB 006 Version 9
Posted: Fri May 13, 2016 6:04 am
by Beertree
A bit late, but 5v targetvol. and the walladapter set ro 9v.