Matrix user forums

Hello,
could you recommend an air oxygen sensor that works with the MIAC MI3846 - Advanced expansion module.
(In my application I need to check continuously the percentage of O2 in the air for safety reasons)
MIAC+MI3846+suggested oxygen sensor can be programmed with flowcode 7? does it have any macro developed for it?
(I guest MI3846 - Advanced expansion module is not supported in flowcode 6)
Thanks
Givoanni

Hello,

There is this O2 sensor from Vernier which is compatible with the sockets on the MI3486 Advanced module.
http://www.vernier.com/products/sensors/o2-bta/

The sensor will likely just return an analogue value so you just need to use the sensor manual to calibrate the sensor and configure your calculations.

Hi Givoanni

Have you looked at Honeywell - they wont be cheep though

http://sensing.honeywell.com/honeywell- ... 4294956300

you may have to include an amplifier as most are mv output's



find your local reseller here

https://sensing.honeywell.com/global-sales-and-service


Steve