Matrix user forums

Hello,

I am new with the flowcode and E-block.
I recently purchaged a EB031( arm ) and a EB063( RF-433 ) and testing with flowcode 7( 30 days trial )

Have downloaded examples, have tried the port B and C with pins in the examples, but i can't get it to work.
The initialise always returns a 0.

Is there someone who can help me with this, all other devices like LCD, RFID ect are working fine, but this is a mind teaser.

Thanks in advance,

Regards,

Rob

Is there nobody who can help me here, i would like to make this work.

Thanks,

Rob V

Hi,
You need to check that the RF-ISM component connection properties match your e-block jumper setting, details are in the EB063 datasheet.
For example, if you attach to port B and set the EB063 patch jumper to position A, your properties should be as below ...
Hope that helps,
Leigh

Hello Leigh,

Thanks for your reply, you are correct, but when i look to the ARM processor pins, the MOSI and MISO are on bit 4 and 5 at port B, this means the jumper on B.
I have tried your suggestion also, but with no luck.

I really do know know why this is not working, it should be so simple.

Hope you have more ideas.

Regards,

Rob