Page 1 of 1
error programming arduino
Posted: Mon Aug 21, 2017 7:54 am
by achillis1
Hello,
What ever code I use from blank code to just on/off led I get error message!
I am attaching below
Thank you
Best Regards
Andreas Achilleos
Re: error programming arduino
Posted: Mon Aug 21, 2017 8:29 am
by LeighM
Hello,
Maybe you have not set the Virtual Serial Port for the Arduino board, see the Flowcode Menu...
Build->Project Options->General Options->Programmer Port
Re: error programming arduino
Posted: Mon Aug 21, 2017 1:44 pm
by achillis1
Hi,
All set correctly here! I have tried with 2 different boards. I used before flowcode with arduino with success I do not know why now displays this error message!
Re: error programming arduino
Posted: Mon Aug 21, 2017 2:05 pm
by achillis1
Hello LeighM
I have changed the arduino Mega 2560 to Mega 2560 R3 and it worked .. so I guess was my fault!
How ever I want to program an arduino UNO wifi, which board should I choose to be correct? Because the target controller list does not include UNO wifi!
Thank you ,
I am sorry for the inconvinience
Re: error programming arduino
Posted: Mon Aug 21, 2017 3:08 pm
by LeighM
I don't know for sure, but I would guess start by trying Uno PDIP
Re: error programming arduino
Posted: Mon Aug 21, 2017 3:58 pm
by achillis1
Hello Leigh,
Will try that! One important thing though if you can help me in this post.
> Arduino UNO wifi has embedded the ESP8266 and as far as I know in order for the arduino to communicate with esp8266 uses different coding and method and probably uses different UART.
Do you have any recommendations for that ? How to design the flowcode?
Thank you
Best Regards
Re: error programming arduino
Posted: Mon Aug 21, 2017 4:12 pm
by LeighM
I don't know about that until we get hold of one to play with
Re: error programming arduino
Posted: Mon Aug 21, 2017 4:29 pm
by achillis1
Yes you are wright but probably arduino has retired that so maybe is best to play with one of these?
https://store.arduino.cc/usa/arduino-mkr1000
Cheers!