Config Fuses for ATTiny13
Posted: Sun Nov 18, 2018 8:39 pm
See attached screenshot for the config fuses for a ATTiny13 as selected ..... This looks very strange !!
If I load up V4 and look at the config fuses it reads 0x0,0xdf.
Also after getting an update file from MM for the ATTiny13 which got the interrupt working, I find that the ADC inputs no longer work at chip level (simulates ok) but they work fine still in V4.
Is there perhaps still problems with the ATTiny13 file ?
Regards
Iain
If I load up V4 and look at the config fuses it reads 0x0,0xdf.
Also after getting an update file from MM for the ATTiny13 which got the interrupt working, I find that the ADC inputs no longer work at chip level (simulates ok) but they work fine still in V4.
Is there perhaps still problems with the ATTiny13 file ?
Regards
Iain