Macro Call without Parameters
Posted: Thu Jun 05, 2008 11:46 am
Hello!
When i call an Macro, which need Parameters and i call it without this in the Simulation, Flowcode tells me this over an Info-Box but it does not stops the Simulation! So i must break the Programm otherwise (Alt-F4, Clicking around to end the simulation) because i am into a loop, after klicking on the OK-Button
Thats very bad for the Version 3.4.7.48!
The German Info was, by the way, also bad ... .
Greetings
Xsusakamei
When i call an Macro, which need Parameters and i call it without this in the Simulation, Flowcode tells me this over an Info-Box but it does not stops the Simulation! So i must break the Programm otherwise (Alt-F4, Clicking around to end the simulation) because i am into a loop, after klicking on the OK-Button
Thats very bad for the Version 3.4.7.48!The German Info was, by the way, also bad ... .
Greetings
Xsusakamei